from 90 to 100%
from 10 to 70%
from 65 to 95%
from 0 to 10%
plaster, wood,
plasterboard
reinforced
concrete
brick,
agglomerate
metal, metallic
protection
PRESENTATION
PREPARATION
The radio siren can be installed outdoor, protected
against direct action of bad weather or in a difficult to
access place, to prevent all types of sabotage.
Radio wave propagation rate
self-protection
rocker
4 loss-proof screws
cover
hole for securing on the wall
speaker
hole for securing
on the wall
battery pack
battery pack
flange
wire sleeve
(mains power
option)
hole for securing
on the wall
fitted only on
the siren with
flashing light
power supply
connector
TEST push-button
POWER SUPPLY
- open the cover,
- loosen the battery
pack flange,
- position or replace
the battery pack,
- tighten the flange,
- connect the battery
pack to the siren
power supply
connector,
- close the cover.
To position or replace the battery pack, put the
control unit in MAINTENANCE PROGRAM mode
(See the Transmission Control Unit Instructions),
before you carry out the following operations:
The self-protection facility (door open o siren
not secured) will trip the siren sound after 4
minutes.
This time period is sufficient to close the siren.
2
1
Discharged batteries indication
Discharged batteries are indicated at every ON/OFF
operation, by a series of acoustic signals.
We advise you to put the discharged batteries in the
appropriate collection bins.
We therefore advise you to test radio
transmission, before definitively installing the
siren (see the “TEST” chapter).
Installation precautions for correct transmission
The radio waves in the room are reflected and
attenuated, according to the structures they
encounter. Propagation may be altered and,
therefore, the products must not be installed near
large metal masses (beams…), or near an electrical
panel.
The outdoor radio siren is available in two versions
(with or without a flashing light). Its function is to
signal an alarm - in case of theft - combined with a
radio transmission control unit of the same range.
The only difference between the two versions is the
flashing light (on the siren thus equipped) which
localises the place broken into when the alarm is
tripped.
Content:
- outdoor radio siren with or without flashing light,
- battery pack for power supply,
- installation and use instructions with drilling
template,
- bag of screws.
3
1
2
3
