6.2
Power
1. The Estate Swing E-SL 1800 comes with 1) 24V transformer. The transformer supplied has 2 screw
terminals to connect to. You may locate the transformer up to
144’ away from the control board
using 2 conductor stranded direct burial wire as specified below
.
C
A
V
o
w
t
e
h
t
o
t
n
i
r
e
m
r
o
f
s
n
a
r
t
e
h
t
m
o
r
f
s
e
r
i
w
o
w
t
e
h
t
t
r
e
s
n
I
.
2
terminals on the control board (CN1). The wires are not polarized, there is no positive or negative.
Do not splice the power cable wire.
Never run 110VAC power directly to the Estate Swing. This will destroy the Estate Swing
control board.
Never connect the power wire with the transformer plugged in. Contact between the two
lead wires, even for a second, will destroy the transformer.
Transformers are only warranted if the internal fuse is not blown. If the fuse is blown an
outside factor (shorting, surge, water, etc) has caused the transformer not to function.
3. Plug the
transformer
into a 110 V AC outlet.
4. The transformer is not weather proof and must be kept in a covered area.
Plug covers are available
from your dealer, contact 1-800-640-GATE for a dealer in your area.
5. Two 12V DC batteries may be run in series as backup to the 24V transformer power. Running two
12V batteries in series creates a 24V system,
you cannot run them in parallel
(see diagram)
6. The power light located below the +24V and –24V output terminals will be on if the power is con-
nected properly. If the light is off then power through the transformer is not functioning properly
and either the unit has no power or is on battery backup.
The light stays off during battery backup.
•
0-36 Feet - Use 16 Gauge
•
37-57 Feet - Use 14 Gauge
•
58-91 Feet - Use 12 Gauge
•
92-144 Feet - Use 10 Gauge
Summary of Contents for Estate Slide
Page 1: ...Instruction Manual for the Manufactured by E SL 1800 Series ...
Page 15: ......
