Kit E850S
18
532181 - Rev.A
57
58
4
Tr
ansla
tion of the original instruc
tions
ENGLISH
6. PUTTING INTO SERVICE
F
Carry out the following operations with the power supply disconnected.
Before installing the board cover and casing you must have:
- completed the start-up procedure
- checked that the C850and the installed devices are working properly.
1. Install the low voltage protection cover on the board E850S and
fasten it in place using the 3 screws that were put aside previously
(
57
).
2. Install the cover and fasten it using the 4 screws that were put
aside previously (
58
).
6.1 FINAL CHECKS
1. Make sure that the forces generated by the leaf are within the
limits permitted by the current regulations. Use an impact force
tester in accordance with standards EN 12453 and EN 12445. For
non-EU countries, of there are no specific local regulations, the
force must be less than 150 N.
2. Check that the maximum force required to move the leaf by hand
is less than 260 N.
3. Check that the C850 and the installed devices are working properly.
7. DIAGNOSTICS
7.1 LEDS CHECK
10
Status of the LEDs
LED
meaning
DL5 OP
opening limit switch
not engaged
engaged
DL6 OP
closing limit switch
not engaged
engaged
DL7 R.OP
deceleration during opening
not engaged
engaged
DL8 R.CL
deceleration during closing
not engaged
engaged
DL9 OPEN
OPEN
input
active
not active
DL10 OPEN B
OPEN B
input
active
not active
DL11 OPEN A
OPEN A
input
active
not active
DL12 SAFE
SAFE
input
not active
active
DL13 FSW CL
FSW CL
input
not active
active
DL14 FSW OP
FSW OP
input
not active
active
DL15 STOP
STOP
input
not active
active
Bold indicates the condition of the LEDs with the board powered, the
gate at its halfway position and no connected device active (
=on
;
=off ).
7.2 STATUS OF THE AUTOMATION
The display, other than when in the programming menu, provides
information regarding the status of the automation:
11
Status of the automation
display
meaning
00
gate closed
02
gate opening/open
04
gate open in pause
06
gate closing
ST
the dead-man function is active and the gate has not yet com-
pleted the opening or closing cycle
ER
the
failsafe
function is active and the test has failed on at least
one device (the
LAMP
output flashes quickly at the same time)
.
8.8
dot on the left lit
FSW OP
input active
.8
.
8
dot on the right lit
FSW CL
input active
Summary of Contents for E850S
Page 1: ...Kit E850S Translation of the original instructions...
Page 19: ......
