ENGLISH
5 INSTALLATION OF THE PHOTOCELL (only for
applications with mobile leaf break-out)
Drill a mm diam. hole at the two ends of the automated
system’s housing (the figure shows that of the 940 model)
so that you can use them to screw-fasten the two photocell
supports (ref.
in the figure) taking care to align them.
Insert inside the photocell supports.
To fit the cable grommet, refer to fig. on page .
Connect the transmitter and receiver of the photocells to
the board controlling the automatic door, taking care to
connect the receiver’s contact to the appropriate STOP
input (refer to the specific instructions of the automatic
door).
6 INSTALLATION OF THE MAGNETIC CONTACT (only for
applications with mobile and semi-fixed leaf break out)
Install the magnetic contact on the door frame and the
magnet on the profile of the semi-fixed leaf.
Next, connect the magnetic contact. on the control board
of the automatic door, in the appropriate STOP input (refer
to the specific instructions of the automatic door).
magnet
magnet
magnetic
contact
magnetic
contact
4 APPLICATION OF SHIMS TO THE MOBILE LEAF GLASS PANEL
Apply shims to the glass panel of the mobile leaf as shown
in the figure below.
Glass
shims
Make the glass panel thicker so that it is
perfectly secured inside the cavity of the
door frame.
Summary of Contents for APN
Page 1: ...APN ...
