9
Opening Angle
a
(inches)
b
(inches)
d(**)
(inches)
c
(inches)
90°
5
1/16
5
1/16
n/a
28
115°
4
4
3/4
n/a
28
6 OUTWARD OPENING
Refer to Table C for this particular application. Select the
operator according to leaf length as detailed in Table 1.
Installation dimensions are provided in Table C.
To adjust the anti-crushing system for outward opening
gates only, perform the following steps (note that these
steps differ somewhat from instructions provided in Section
4.1):
• OPEN screw (green wording): gate closing direction.
• CLOSE screw (red wording): gate opening direction.
• To reduce torque, turn screws counter-clockwise.
• To increase torque, turn screws clockwise.
4 SYSTEM TEST
When you have finished installing the unit, run a functional
check of the automated system and all accessories con-
nected to it, especially safety devices.
(**) The dimension is not a constraint
Figure 17
Table C: Standard Operators Recommended Dimensions
5 MANUAL OPERATION
If the gate has to be moved manually due to a power
failure or a fault in the system, use the release device as
described below.
• Lift the protective plug (Fig. 16, Ref. 1) and insert the
supplied key (Fig. 16, Ref. 2).
• Turn the key 90°clockwise to open the cover.
• Lift the cover (Fig. 16, Ref.3).
• Turn the release knob counter-clockwise approximate-
ly two complete turns (Fig. 16, Ref. 4).
You can now open or close the leaf manually.
5.1 RESTORING NORMAL OPERATING MODE
To prevent an involuntary pulse from activating the
operator during manual operation, cut power to the
system before re-locking the operator.
• To re-lock the operator, turn the release knob clock-
wise until it stops (Fig. 16, Ref. 4).
• Do not force the red knob as it’s designed to strip out
before damaging the operator.
• Close the cover and turn the key 90° counter-clock-
wise (Fig. 16, Ref. 2).
• Finally, remove the key and close the protective plug
(Fig. 16, Ref. 1).
Figure 16
Opening Angle
a
(inches)
b
(inches)
d(**)
(inches)
c
(inches)
90°
7
7/8
7
1/2
n/a
32
3/4
115°
5
3/4
7
n/a
32
3/4
Table D: EG Operators Recommended Dimensions
