F5 WANJet 500, Platform Manual

Page: 30 / 77

Chapter 2
2 - 8
4. Log in as admin with the default password of admin .
A message displays a list of commands that you can use from the
command line.
5. To start configuring the addresses, type config .
6. At the Set WANJet IP prompt, type the IP address of the WANJet
appliance (default is 192.168.168.100 ).
7. At the Set WANJet NetMask prompt, type the netmask you want
to assign to the WANJet appliance (default is 255.255.255.0 ).
8. At the Set WANJet Gateway prompt, type the IP address of the
WANJet appliance gateway (default is 192.168.168.001 ).
The media types are displayed.
Type 0 for Auto Sense
Type 100F for 100BaseTX Full-Duplex
Type 100H for 100BaseTX Half-Duplex
Type 10F for 10BaseT Full-Duplex
Type 10H for 10BaseT Half-Duplex
9. To set the media type, type the appropriate alphanumeric code that
represents the desired speed and duplex setting for the eth0 (LAN)
and eth1 (WAN) media types. You can use the default value of
Auto Sense unless you are familiar with the settings required in
your network environment and want to change them.
10. To manage the WANJet platform from a separate management
subnet, you can optionally set the IP addresses for the WANJet
Management IP , WANJet Management NetMask , and WANJet
Management Gateway . (These options are blank, by default.)
11. Determine how you want to allow access to the Web UI.
• To allow access from one IP address, at Set the IP of the first
machine allowed to access WANJet UI, type the IP address of
the only computer that you want to access the Web UI.
• To allow access from multiple IP addresses, leave this blank (the
default). In the navigation pane, expand Security and click IP
Access Control . See Granting Web UI access in the WANJet
®
Appliance Administrator Guide.
• To allow access from any browser on any computer in your
network (using the correct user name and password), leave this
field blank (the default).
12. Type exit to disconnect the session.
Within a few seconds, the LCD panel displays the IP address you
configured for the WANJet appliance.
Continue with the section called, Connecting the cables , on page 2-9.