F5 Viprion, Platform Manual

Page: 40 / 97

Chapter 4
4 - 6
Specifying media type
You can configure the media type on an interface.
Important
If you manually configure the platform to use specific speed and duplex
settings on interfaces, Auto MDI/MDIX functionality is turned off by default.
Additionally, when an interface is set manually, it functions as a data
terminal equipment (DTE) port. This means that crossover cables are
required to connect to other DTE devices (for example, servers), and
straight-through cables are required for connecting to data communications
equipment (DCE) devices (for example, switches or routers). Be sure to use
the correct cable type (straight-through or crossover) if you manually set
interface speed and duplex settings.
INTERFACE
Key Speed Pkts Pkts Drop Coll Bits Bits Errs Trunk
Mbps in out in out
1/1.1 MS 10000 FD 0 0 0 0 0 0 0
1/1.2 MS 10000 FD 0 0 0 0 0 0 0
1/2.1 DN 1000 FD 0 0 0 0 0 0 0
1/2.2 DN 1000 FD 0 0 0 0 0 0 0
1/2.3 DN 1000 FD 0 0 0 0 0 0 0
1/2.4 DN 1000 FD 0 0 0 0 0 0 0
1/2.5 DN 1000 FD 0 0 0 0 0 0 0
1/2.6 DN 1000 FD 0 0 0 0 0 0 0
1/2.7 DN 1000 FD 0 0 0 0 0 0 0
1/2.8 DN 1000 FD 0 0 0 0 0 0 0
1/3.1 MS 1000 FD 0 0 0 0 0 0 0
1/3.2 MS 1000 FD 0 0 0 0 0 0 0
1/3.3 MS 1000 FD 0 0 0 0 0 0 0
1/3.4 MS 1000 FD 0 0 0 0 0 0 0
1/3.5 MS 1000 FD 0 0 0 0 0 0 0
1/3.6 MS 1000 FD 0 0 0 0 0 0 0
1/3.7 MS 1000 FD 0 0 0 0 0 0 0
1/3.8 MS 1000 FD 0 0 0 0 0 0 0
1/3.9 MS 1000 FD 0 0 0 0 0 0 0
1/3.10 MS 1000 FD 0 0 0 0 0 0 0
1/3.11 MS 1000 FD 0 0 0 0 0 0 0
1/3.12 MS 1000 FD 0 0 0 0 0 0 0
1/mgmt UP 1000 FD 13724 74 0 0 28.08M 80736 0
Figure 4.2 bigpipe interface command output
Interface Properties Description Default
media You may specify a media type or use
auto for automatic detection.
auto
Table 4.7 Attribute you can configure for an interface