F5 BIG-IP 10000 Series, Platform Manual

Page: 23 / 68

Description Option Letter
Configures the baud speed for connecting to AOM using the serial
console. Select from these options: Set console baud rate B
• 9600
• 19200 (default)
• 38400
• 57600
• 115200
Displays information about the AOM firmware and bootloader, chassis
serial and part numbers, blade serial number, MAC address, and power
status for the active console. Display platform
information I
Powers the host subsystem on or off. Power on/off host
subsystem P
Resets the host subsystem with a hardware reset.
Important: F5
®
does not recommend using this option under typical
circumstances. It does not allow for graceful shutdown of the system.
Reset host subsystem R
Runs the AOM network configuration utility. This utility enables you
to reconfigure the IP address, netmask, and default gateway used by Configure AOM network N
AOM. If you use this option while connected using SSH, your session
will be disconnected as a part of the network configuration operation.
Note: This option is not available when you are connected using SSH.
Sets a session idle timeout (in seconds) for the AOM SSH server.
Available values are 0 (no timeout; default value), or between 30 and
86400 (one day). Configure SSH Server S
Resets the AOM subsystem. In this case, the system is reset with a
hardware reset.
Important: We do not recommend using this option under normal
circumstances. It does not allow for graceful shutdown of the system.
Reset AOM A
Buffers the last 4K bytes of console output from the host and saves it
to a non-volatile storage location.
Important: This option is hidden and disabled by default. It is intended
to be used as a diagnostic tool by F5 Support. When this option is
enabled, then disabled, the buffer is cleared.
Host Console Capture
Buffer H
Displays a list of latched events/errors or out-of-range sensors. Display error report E
Exits the AOM Command Menu and returns to terminal emulation
mode. Quit menu and return to
console Q
Accessing the AOM Command Menu from the serial console
You can access the AOM Command Menu using the front panel serial console.
23
Platform Guide: 10000 Series