TOP
-ino
User Manual
17 of
25
F+D
Feinwerk- und Drucktechnik GmbH
Kirchenstraße 38, D - 69239 Neckarsteinach, Germany
Phone: +49 6229 7000, Fax: +49 6229 70067
E-Mail: [email protected], Internet: http://www.fuddruck.de
4.2 Changing the thermal
head
1. Follow the steps 1. to 4. of changing the color ribbon.
2. Release the cable connection to the thermal head (pull up
and off).
3. Remove the two screws on the mounting of the thermal
head (Ill.).
4. Pull the thermal head with heat sink off to the front.
5. Insert the new thermal head very carefully.
6. Tightened the two fastening screws.
7. Re-establish the cable connection to the thermal head,
doing so, you must assure of a stable connection.
8. Follow the steps 5 to 11 of changing the color ribbon.
8. Connect the Centronics cable. Switch on the
TOP-
ino
and wait for initialisation.
10. Insert the diskette to the floppy drive of the PC.
11. Start the program setuppre.exe under MS-DOS
.
Check the head number and the port (Normal LPT1). It
takes around 1min time.
12. Switch off the
TOP-
ino
.
13. Switch on the
TOP-
ino
.
14. Print a testcard.
Note:
On the testcard must be the new headnumber and the
head count = 0.
With this software we are setting the voltage of the thermal
head and loading the correction table for every dot of the head.
4.3 Changing the cleaning
rolls
1. Switch the printer off.
2. Pull the two cleaning rolls up and off (Ill.).
3. Insert new, i.e. cleaned and dry rolls. To do so, insert
the rolls from the top and push them down.
4. Switch the printer on again.
The cleaning rolls may be cleaned again with tab water and put
them dry back. Cleaning should take place according to
contamination.
Summary of Contents for TOP-ino
Page 2: ......
