38
Customer Service 1-800-377-4532
Currie Technologies
®
Section 7 - PRE-RIDE CHECkLIST
It is recommended that you perform each of these checks before each and every ride.
TIRES
Check tires for any cuts or unusual wear.
□
Check tire pressure and inflate to recommended pressure as necessary.
□
HANDLEbARS and fRAME
Inspect for bent, damaged or cracked welds and tubing caused by aggressive
□
riding.
Ensure the handlebars are properly aligned and secured tight enough so that you
□
cannot twist them out of alignment.
NUTS and bOLTS
Inspect and tighten all fasteners before each and every ride.
□
If unsure on how to inspect and tighten fasteners, seek advice from an authorized
□
and experienced mechanic.
bRAkES
Ensure brake control cable(s) are lubricated, correctly adjusted and display no
□
obvious wear.
Ensure brake control lever(s) are not binding and the clamps are tightly secured to
□
the handlebar.
Squeeze the brake lever(s) to make sure that it does not bottom out on the handle-
□
bar and the brake(s) holds the scooter from being pushed forward.
Squeeze the brake lever(s) to ensure the brake inhibitor(s) stop the motor.
□
Ensure brake shoe pads are not worn out and are correctly positioned.
□
ELECTRICAL SYSTEM
Be sure the batteries are fully charged by using the battery gauge (colored LED’s)
□
on the throttle.
Ensure your battery pack is properly installed in your scooter with the deck plate
□
attached and secured.
Ensure the accelerator are secure, in good condition and working properly.
□
RIDING GEAR
Always wear an approved helmet.
□
Always wear proper protective equipment such as; eye protection (goggles or face
□
shield), gloves, boots, long sleeved shirt or jacket and long pants.
Never operate this product barefoot or in sandals as this increases the risk of
□
injury.
Always obey all local traffic laws
□
