11
1 Set current day and time
1.
Press
once. When
“MON” (Monday) begins flashing, use
to select the current day.
2.
Press
. When the hour digits begin flashing, use
to select the current hour.
3.
Press
again. When the minute digits begin flashing, use
to select the current minute.
4.
Press
again. The current time is now set.
2 Set ON/OFF time and temperature on a weekly cycle
1.
Press
. When “MON” begins flashing, press
3 times. When “ON” begins flashing, use
to select
the desired hour and minute to turn on the heater. Press
to clear
the digits and shut down “ON” timer.
2.
Press
. When “OFF” begins flashing, use to select the desired hour and minute to turn off the heater.
Press
at any time to clear the digits and shut down
“OFF” timer.
3.
Press
again. When “18” begins flashing, use
to select the desired temperature for Monday.
4.
Press
again. When
“TUES” appears on the screen and “ON” begins flashing, use
to select the desired
hour and minute to turn on the heater for Tuesday.
5.
Press
again. When “OFF” begins flashing, use
to select the desired hour and minute to turn off the
heater for Tuesday.
6.
Press
again. When “18” begins flashing, use
to select the desired temperature for Tuesday.
7.
Repeat
steps 1 to 6 to set the “ON/OFF” time and temperature for Wednesday, Thursday, Friday,
Saturday, and Sunday.
8.
Press
or
to finish, ensuring to aim the remote control at the receiver located in the middle of the
appliance. The appliance will “beep” once to confirm your settings have been saved successfully.
Open window warning
If the room temperature decreases by 10 degrees within 3 minutes, the appliance will assume there is an open window
nearby. To conserve energy, the heater will automatically switch from High Heat to Low Heat, or if the heater is already at
Low Heat, it will turn off completely.
When switching from High Heat to Low Heat, the appliance will beep 3 times and the digital display will flash
“88” 3 times
before displaying the existing heating status.
When switching from Low Heat to Off, the appliance will beep 3 times and the digital display will flash
“88” continuously.
To
reset the heating function, see “operating remote control” section. A simple switch of off then on should work.
note:
If the temperature was previously set, those digits will be shown instead of
“18”.
note:
The timer can only be adjusted in 30-minute intervals (i.e. 00:00 - 00:30; 00:30 - 01:00, etc.)