38
Replace the wheel nuts onto the axle and make them finger tight against the dropout. Using an 18mm
spanner begin to tighten the nuts. Start on one side, and then move to the other, bit by bit (don’t tighten
up just one side first fully and then the other). Finally tighten the nuts fully all the while holding the
wheel with one hand making sure that the wheel is sat in the middle of the frame, and that the brake
rotor is sat inside the brake caliper.
You can now place the cable protector over the right hand wheel nut and connect the motor to
the electric system using the quick connect cable male/female adaptors (line up the arrows on the
connectors to help you connect in the correct position).
To remove the wheel simply reverse these steps.
Turning your e-bike upside down and resting it on the handlebars and saddle is
not recommended, as you may incur damage to the saddle and to the gear shifters
and brake levers. We always recommend using a bike stand for maintenance
work on your e-bike.