15. Attach camera. You can attach
directly or via a fluid or motorized
pan tilt head.
16. Add or remove weights to
achieve camera balance. Use
the spring clips to secure them
and the adjust the Sliding weight
for micro adjustments.
11. Place the provided level on to the
camera platform. Use the turnbuckle
to adjust the platform and achieve
level.
13. Attach the sliding counter
weight to the Tail beam of the
Jib via the bungee straps
12. Finger tighten or use the pro-
vided wrench to tighten the nuts
against the turnbuckle body to se-
cure the setting.
14. Attach the counter weight bar to
the Tail End of the Jib. Use the hex
tool to tighten the set screw (at butt
end) to secure it in place.
Skinny Jib SETUP INSTRUCTIONS - 4’ Configuration
STOP/ NOTE: The Skinny Jib can be used at 2’ or 4’ Configuration.
Below are the instructions for the 4’ Configuration. (Pages 8, 9 & 10)
Refer to pages 5, 6 and 7 for instructions on the 2’ configuration
