User Manual MUT_RD_009H_GB Page
37
of 43
5.3.6
Step 6
. Treatment completion
1.
When treatment is completed, suction automatically stops. Release the firing pedal.
2.
The Control Unit automatically displays the
Treatment Report screen describing operations
carried out for each sector, and a first automatic
print (default print) is delivered by the printer
located at the rear of the Control Unit.
Additional prints of the treatment report can
be obtained by pressing on
.
Even if the automatic printing is disabled in
the Settings Menu (§4.2), if one or more
interruptions occurred during the treatment,
an automatic print is systematically delivered.
Accuracy of values displayed is as follows:
•
Negative pressure : ± 5%
•
Firing time : ± 0.1 sec
•
Frequency : ± 10 Hz
•
Power : ± 10%
3.
Remove the coupling cone and therapy probe from
the patient’s eye, while carefully sponging up th
e
liquid contained in the center of the device, and
discard everything appropriately (contaminated
waste).
4.
Disconnect the therapy probe by grabbing it by the
lower side of the connector, then raise
the “lock
ing-
ring” allowing
an easy disconnection (see picture
aside).
5.
Move to the next step by pressing on the blue
arrow in the bottom right corner of the screen.
6.
Shut down the Control Unit by pressing the ON/OFF
button on the side of the device.
OR
Select the
RESTART
icon to start a new treatment -
with the same user or not- without shutting down
the Control Unit.