www.eyehortilux.com
7
Note: The displayed temperature may take some time to level out.
Note: If the length of the sensor cable is insufficient to reach the controller, try to relocate the controller. If this is
not possible, the sensor cable may be lengthened an extra 5 meters by using a standard 3.5 mm jack extension
cable. If the message “sensor removed” appears, the plug of the sensor is not (fully) plugged in. Plug the sensor
in completely.
Note: If the message “sensor failure” appears, the sensor is defective. Replace the sensor.
4.3 Connecting Equipment Which Must Be Used During Lights-off Periods
Example: a heater may be activated during lights-off periods.
1. Connect the EEM cable to the cage clamps marked “EEM2” (Figure 7)
2. Connect the auxiliary equipment which must be activated during lights-off periods to the EEM cable
connected to clamps marked “EEM2.”
Aux
Room
Auxiliary
equipment
(lights on)
Auxiliary
equipment
(lights off)
Main
Room
Auxiliary
equipment
(lights on)
Auxiliary
equipment
(lights off)
EEM2
EEM1
1
2
