Operating Manual
14
3.8 iANT218 / iANT221
1.
Place item No.2 on the antenna, as
illustrated in the drawing. Align with the
screw holes.
2.
Connect item No. 2 to the antenna with
spring washers (11), flat washers (10) and
nuts (12).
3.
Tighten the nuts at a torque of 30 Lbs*In.
4.
Connect item No. 3 to item No. 2 ONLY as
illustrated in Fig.2, with items 6, 7,8,13.
(Teeth of item 2 facing teeth of item 3)
Leave screw slightly loose.
5.
Connect item No. 3 to item No. 5 as
illustrated, with items 6, 7,8,13. (Teeth of
item 5 facing teeth of item 3) Leave screw
slightly loose.
6.
For pole mounting attach items No. 4 and 5
to the pole as illustrated (Fig 4), and connect
those using items No. 6, 7, and 9. Close
screws (9) one and another in turn up to
tightening torque of each screw is 30...35
Lbs·In. Distance between ends of items 4, 5
on one and another side must be equal. NO
SKEWNESS ALLOWED.
7.
For wall mounting attach item 5 to the wall
(Fig 5). Fasten it with screws 1/4” or M6
using holes “A”. (Screws not supplied).
8.
Adjust the desired angle, and fully tighten
the loose screws (paragraphs 4, 5) at a
torque of 30 Lbs·In.
