VNR 100 • Replacing the VNR 100 Drives
16
1.
Switch the recorder off
by pressing and holding
down the power switch
(figure 14,
A
) until the LEDs
(
B
) flash red and then go
out.
2.
Unplug the recorder.
3.
Press the red catch. The
lever arm is released (see the
figure to the right).
4.
Swing the lever arm out until
it is perpendicular to the front
of the drive caddy (as shown
in the figure to the right). Use
the arm to pull the caddy out
of the drive bay.
5.
Remove the drive. There are
no screws to be removed or
cable connections to be undone.
6.
Insert the new drive into the drive bay.
7.
Push the caddy back into the recorder.
8.
Swing the lever arm back until it clicks into place behind the catch.
ATTENTION:
Do not power on the unit at this time.
ATTENTION:
Ne branchez pas l’unité à ce moment là.
Configuring the New Drive
1.
Attach a mouse to the rear panel PS/2 mouse port
(
E
) and a keyboard to the rear panel PS/2 keyboard
port (
F
). Alternatively, you may connect the mouse
and keyboard to the front panel USB ports (see
figure 15
,
C
on the previous page) or the rear panel
USB ports (
D
in the figure to the right).
2.
Connect a VGA monitor to the rear panel port (
G
).
3.
Power on the recorder by pressing the front panel
power switch ( see
figure 15
,
A
).
4.
Power on the monitor. The login screen
is displayed.
5.
Enter the
Username
and
Password
.
NOTE:
By default, the
Username
is
matrix_rec
and the
Password
is
matrix
.
A
B
C D
D
E
H
G
F
Summary of Contents for VNR 100
Page 6: ...VNR 100 Contents vi ...