Extron electronics TLI Pro 201, User Manual

Page: 11 / 46

Installation
Overview
1.
Before starting, download and install the latest versions of the following software:
Toolbelt — Provides device discovery, device information, firmware updates,
and configuration of network settings, system utilities, and user management for
TouchLink Pro interfaces.
Global Configurator Professional and Global Configurator Plus — For
setting up and configuring the control processor, interface, and third-party
touchpanel.
GUI Designer
— For designing layouts for Extron TouchLink Pro interfaces and
third-party touch interfaces.
Global Scripter — Provides an integrated development environment for Extron
control systems programming.
See Configuration Software on page 23.
2.
Obtain the following network information from your network administrator:
DHCP setting ( On or Off ). If the DHCP setting is off, you also need:
Interface IP address
Subnet mask
Gateway IP address
Usernames — By default these are either
admin
or
user
.
Passwords — The factory configured passwords for all accounts on this device
have been set to the device serial number. Passwords can be changed during
configuration. They are case sensitive.
NOTE:
If the device is reset to default settings, the passwords are reset to
the defaults, which are extron (for either admin or user accounts).
MAC address — Make a note of the interface MAC address (see the label on the
rear panel of the device).
3.
Mount the TLI Pro 201 in a standard rack, or use an under-table mounting kit
(see
Mounting on page 30). To mount the third-party touch display follow the
instructions provided by the manufacturer.
4.
Connect cables to the TLI Pro 201 (see TLI Pro 201 Rear Panel Features and
Connections on page 5).
Connect an HDMI source to the HDMI input of the TLI Pro 201 ( figure 2 ,
A
, on
page 5) .
Connect the HDMI output from the TLI Pro 201 (
B
) to the third-party touch
display.
Connect the USB port from the TLI Pro 201 (
C
) to the third-party touch display.
NOTE: The USB connection passes information to the TLI Pro 201 about where on
the screen the touch display was pressed. If you are using a non-touch display,
connect a USB mouse to the USB port on the TLI Pro 201 and use the mouse
to click on screen buttons.
TLI Pro 201 • Installation Overview 3