Extron electronics Quantum Connect 82, User Manual

Page: 78 / 93

Quantum Series Videowall Processing Systems • QC 101 Controller 70
Installation and Connections
QC 101 Rear Panel Connections
The rear panels of the QC 101 E and the QC 101 C are identical except for a label
indicating the model (QC 101 E or QC 101 C).
100-240V ~ 0.5A MAX
50-60 Hz
OUTPUTS
OUTPUTS
REMOTE
USB CONTROL
DISPLAYPORT
1
3
LAN 1 LAN 2
VGA
RS-232
Tx Rx G
RESET
2
1
2
HDMI
H H H
G G G
F F F E E E D D D C C C B B B A A A
A
AC power connector
E
VGA output connector
B
DisplayPort output connector
F
Remote RS-232 connector
C
USB connectors
G
Power button
D
LAN connectors
H
HDMI output connector
Figure 59. QC 101 Rear Panel
A
AC power connector — Connect the supplied IEC power cord between this male
IEC connector and an AC power source.
B
DisplayPort output connector — (Optional) Connect an external display that
supports DisplayPort to this connector for use when configuring a Quantum
processor using the Quantum Configuration Software.
C
USB connectors
— Connect a mouse and keyboard (or a keyboard and mouse
combination), and a flash drive (if needed), to these two connectors to create and
save Quantum Elite or Connect configuration project files (see the
Quantum Control
Software User Guide , available at
www.extron.com
for details on using the Quantum
Configuration Software).
D
LAN connectors — These two RJ-45 connectors support 10/100/1000 Base-T.
Connect either of these ports to a LAN or directly to the Control connector on a
Quantum chassis to enable communication with the processor.
NOTE: The QC 100 must be connected to the same subnet as the Quantum
processors.
E
RGBHV output connector
— (Optional) Connect an RGB display to this 15-pin VGA
connector for use when configuring the system using the Quantum Configuration
Software.
F
Remote RS-232 connector — Connect a control system (such as an Extron IPCP
or IPL Pro Control Processor) to this 3-pole captive screw connector for remote
control of the videowall via RS-232 (see the
Quantum Control Software User Guide
for the commands).
G
Power button — Using a small screwdriver or stylus, press this recessed button
momentarily to safely shut down the controller. Pressing and holding the button for
5 seconds forces a hard shutdown of the QC 101.