NAV SD 511 Scaling Decoder • HTML Operation
18
HTML Operation
This section introduces using the built-in HTML pages to configure and operate the
NAV SD 511 decoder, including:
•
Opening the Embedded HTML Pages
•
The decoder can be controlled and operated through either the front panel Configuration
(USB) port (see
on page 12) or the rear panel NAV 1G port (see
page 6). The Configuration port uses IP over USB technology. The factory-embedded HTML
pages are always available and cannot be erased or overwritten.
Opening the Embedded HTML Pages
Access the decoder using HTML pages as follows:
1.
Start the web browser.
NOTE:
•
Extron recommends the following browsers to fully support the NAV system:
•
Google Chrome — All screen images in this guide use Chrome
•
Mozilla Firefox
•
Microsoft Edge
•
The network must be properly configured for multicasting (IGMP). Failure to do
so may result in degraded performance.
2.
Click in the
Address
field of the browser and enter the IP address.
NOTES
:
•
For the NAV 1G port, if unit does not receive an IP address from the DHCP
server, it self-assigns a Link Local IP address in the range 169.254.
X
.
X
.
•
Default settings:
Port
DHCP
IP address
Subnet mask
Config
(USB)
*
203.0.113.22
NAV 1G
(fiber)
On
* For the Config port
, the address for IP over USB
CANNOT
be changed.
•
If you use IP over USB, Extron recommends waiting a minute after plugging in
the cable for your PC to identify the USB connection as a valid Ethernet port.
