Extron electronics NAV SD 101, User Manual

Page: 20 / 82

NAV SD 501 and NAV SD 101 Scaling Decoders • Installation 12
PRELIMINAR
Y
C
NAV LEDs (see page 11 )
Video LED — Indicates the status of the input video stream.
Lit steadily
— The unit is decoding the video input stream.
Blinking — The unit is decoding the video input stream, but network errors are
present that affect the image.
HDCP LED — The video input stream is HDCP encrypted.
Audio LED — Indicates the status of the input audio stream.
Lit steadily
— The unit is decoding the audio input stream.
Blinking — The unit is decoding the audio input stream, but network errors are
present that affect the audio quality.
USB LED (NAV SD 501 only) — Indicates status of the USB stream.
Lit steadily - The decoder is actively receiving and sending a NAV USB stream.
Blinking — The decoder is not actively sending and receiving a NAV USB Stream.
Unlit — The decoder is unable to establish a NAV USB stream.
D
Audio LEDs
HDMI Audio LED —
Lit steadily — HDMI audio output is being output on the HDMI port (see
B
on page 6).
Unlit — HDMI audio is muted.
Analog Audio LED —
Lit steadily — HDMI audio output is being output on the audio port (see
C
on page 6).
Unlit — HDMI audio is muted.
E
USB LEDs (NAV SD 501 only) — Indicates the status of the USB stream, as follows:
Host LED
Lit steadily – The decoder is in USB host mode.
Unlit – The decoder is in USB device mode, the default condition.
Active LED
Lit steadily – A USB device or host is connected to the rear panel USB port.
Blinking – A USB device or hub is connected to the decoder and is attempting
to draw more power than the USB port can supply.
Unlit – No host or USB device is connected to the rear panel USB port.
F
LAN LEDs — Indicate the status of the network connection, as follows:
NAV LED (NAV SD 501) or LAN LED (NAV SD 101) —
Link LED — Lit steadily indicates that a network link is established. Blinking
indicates a link speed less than 1G.
Act LED — Blinking indicates network traffic. The blink rate corresponds to activity.
Ext LED (NAV SD 501 only) —
Link LED — Lit steadily indicates that a network link is established. Blinking
indicates a link speed less than 1 Gbps.
Act LED — Blinking indicates network traffic. The blink rate corresponds to activity.
G
ID button and LED — The recessed ID button identifies the decoder to the network
when pressed. The LED blinks when the decoder is in pairing mode and lights steadily
when it is paired or device identification is selected from the decoder or NAVigator
HTML page.