Extron electronics NAV SD 101, User Manual

Page: 14 / 82

NAV SD 501 and NAV SD 101 Scaling Decoders • Installation 6
PRELIMINAR
Y
A NAV 1G/PoE+ port (see figure 2 on page 5) — Connect to an
NAV 1G/PoE+
LAN
Ethernet LAN on which one or more encoders also reside for
streaming, control, and PoE+.
NOTES:
• See TP cable termination on page 7 to properly wire the
RJ-45 connectors A and F .
• The Extension port ( F ) cannot provide PoE.
• RJ-45 port LEDs for both ports indicate as follows:
• Act (amber) LED — Indicates transmission of data packets on the RJ-45
connector. This LED blinks as the decoder communicates.
•
Link (green) LED — Indicates that the decoder is properly connected to
an Ethernet LAN. This LED lights steadily.
B HDMI output port — Connect an HDMI cable between this port and
HDMI
an HDMI display. See
LockIt Lacing Brackets
on page 8 to use the LockIt
HDMI Cable Lacing Bracket to secure the connector to the decoder.
C Audio output port — This 5-pole, 3.5 mm captive screw connector
L R
AUDIO
outputs the streamed, unamplified, line level analog audio. Connect an
audio device, such as an audio amplifier or powered speakers (see
Analog audio connector on page 9 to wire the connector).
D Control (RS-232/IR port — Connect a serial RS-232 signal, a modulated
RS-232
Tx Rx G S G
IR
IR signal, or both to this 3.5 mm, 5-pole captive screw connector for
bidirectional RS-232 and IR communication (see
Control connector
wiring on page 9 to wire the connector).
E USB 2.0 port (NAV SD 501 only) — Connect a USB Type-C cable from a
5V/500 mA
USB 2.0
USB host or a USB device. See
LockIt Lacing Brackets
to securely fasten the
USB connector to the decoder.
NOTE: This connector is limited to supplying 500 mA in USB device mode.
F Extension port
(NAV SD 501 only) — If desired, connect another
EXT
networked device to this port. The port acts as a networked switch to the
NAV 1G/PoE+ port (
A
).
G
Reset button and LED — The Reset button initiates three levels of
RESET
decoder reset. For the different reset levels, press and hold the button while the
decoder is running or while you power up the decoder (see
Reset Operations
on page 15 for details).
H
Power connector — Plug the included external 12 VDC power supply into this
POWER
12V
2.0 A MAX 2-pole connector.
NOTE: Alternatively, the decoder can be powered via PoE+.
ATTENTION:
• Do not connect power to the decoder until you have read the CAUTION and
ATTENTION notices on pages 10 and 11.
• Ne connectez pas l’alimentation à l’encodeur avant d’avoir lu les rubriques
«
ATTENTION » des pages 10 et 11.