Extron electronics NAV E 201 D, User Manual

Page: 27 / 79

NAV E 401 D and NAV E 201 D Encoders • Basic Operation 19
Reset Mode Comparison and Summary
Mode Activation Result Purpose and
Notes
1
Hold down the recessed
RESET
button while
applying power to the unit.
NOTE: After a mode 1 reset is
performed, update the unit firmware
to the latest version. Do not operate
the unit firmware version that results
from the mode 1 reset. If you want
to use the factory default firmware,
you must upload that version again
(see
FIRMWARE tab on page 39 for
details on uploading firmware).
The unit reverts to the factory default firmware. All user files
and settings, such as IP settings, are maintained.
NOTE: If you do not want to update firmware, or you
performed a mode 1 reset by mistake, cycle power to
the unit to return to the firmware version that was running
before the mode 1 reset (see
About Page on page 57 to
find the firmware version).
Use mode 1
to return the
unit to the
factory default
firmware version
if incompatibility
issues arise with
user-loaded
firmware.
Har
dwar
e r
eset
4
Hold the
RESET
button for approximately
6 seconds, until the RESET LED blinks twice
(once at 3 seconds and again at 6 seconds).
Then momentarily press
RESET
within 1
second
.
Resets all the IP settings without affecting the device
configuration. Mode 4:
• Enables ARP capability.
• Sets the IP address, subnet address, gateway address, and
port mapping to the factory default.
• Sets the Multicast IP, stream number and device name to the
factory default.
•
Turns DHCP on.
The RESET LED blinks three times in succession during the reset.
Mode 4 enables
you to set
IP address
information using
ARP and the
MAC address.
Reset IP (SW)
settings
5
Hold the
RESET
button for approximately 9
seconds, until the RESET LED blinks three times
(once at 3 seconds, again at 6 seconds, and
then again at 9 seconds). Then momentarily
press
RESET within 1 second.
NOTE: Mode 5 reset reverts the factory-
configured username to
admin
and
password to extron .
Mode 5 performs a complete reset to factory defaults (with
the exception of the firmware):
• Does everything mode 4 does.
• Resets all settings with the exception of factory firmware.
• Resets all IP options.
• Removes all files from the unit.
• Removes the initial serial number passwords and sets them
to
extron
.
The reset LED blinks four times in succession during the reset.
Mode 5 is for
starting over with
configuration
and uploading
or to replace
events. Same as
the
E
ZQQQ
}
SIS command
on page 64.
Factory (SW) r
eset