NAV E 401 D and NAV E 201 D Encoders • Installation
10
Complete the Physical Installation
Mount the encoder to a wall or furniture as follows:
NOTE:
Extron recommends taking safety precautions to avoid electrostatic discharge
issues during installation.
1.
Insert the cabled encoder into the mud ring or junction box within the wall or furniture,
aligning the mounting holes in the encoder mounting tabs with those in box or mud
ring.
2.
Secure the encoder to the junction box, wall or surface mounting box, or mud ring as
follows (see figure 5):
NAV E 201 D
HDMI OUT
E
E
STRM
HDMI
HDCP
PWR
Mounting
Screws
(6 Plcs)
Figure 5.
Installing the Encoder in a Junction Box
3.
Insert the included screws through the mounting holes at diagonal corners of the unit
and into the corresponding threaded holes in the box or mud ring.
4.
Using a Phillips screwdriver, tighten the screws until snug.
ATTENTION:
•
Do not overtighten the screws.
•
Veillez à ne pas trop serrer les vis.
5.
Attach the faceplate to the encoder: insert the six included screws through the circular
holes in the faceplate and the tabs on the encoder. Tighten the screws using a flat
bladed screwdriver until snug.
Summary of Contents for NAV E 201 D
Page 6: ......
Page 8: ...NAV E 401 D and NAV E 201 D Encoders Contents viii...
