10
MTP 15HD A Series • Installation and Operation
1
. Remove the feet from the bottom of the MTP, if they are
installed.
2
. Attach the mounting brackets to the MTP with the
provided machine screws.
3
. For furniture mounting, hold the MTP with the attached
brackets against the mounting surface. Mark the bracket
screw hole locations on the mounting surface.
4
. For furniture mounting, drill 3/32 inch (2 mm) diameter
pilot holes, 1/4 inch (6.3 mm) deep in the mounting surface
at the marked screw locations.
5
. For furniture mounting, insert number 8 wood screws into
the four pilot holes. Tighten each screw into the mounting
surface until just less than 1/4 inch (6 mm) of the screw head
protrudes.
6
. For furniture mounting, align the mounting screws with the
slots in the brackets and place the MTP against the surface,
with the screws through the bracket slots.
7
. For furniture mounting, slide the MTP slightly forward or
back, then tighten all four screws to secure the MTP in place.
8
. For projector mounting, secure the MTP to a projector mount
by inserting the mounting bolt through the slotted hole on
the bracket and tightening the bolt.
MT
P S
ER
IE
S
INPU
T
OUTP
UT
PO
WER
12
V
.5
A M
AX
M
T
P
R
1
5
H
D
A
ON
1
2
3
4
5
6
H SY
NC
+
V SY
NC +
C S
YN
C
SO
G
VIDEO
SPA
RE
1 MONO
A
UDIO
2
Projector
PMK 100
Projector
Mounting
Bracket
MBU 123
Under-Desk
Mounting
Bracket
Mounting
Bolt
Figure 5 — Desk and projector mounting the MTPs
