Operation, cont’d
MAV 44 / 48 / 84 / 88 Matrix Switchers • Operation
3-26
Resetting the system to factory defaults (audio/video switchers)
To reset an audio/video switcher to the factory default settings, press and hold the
I/O button on the front panel while applying AC power (figure 3-43). Continue to
hold the I/O button until all LEDs light and then release the I/O button. The
power up sequence completes (all LEDs turn off then turn on and off from left to
right, the Video and Audio LEDs turn on, and all other LEDs remain off). System
reset:
• Clears all ties and presets
• Clears all video and audio mutes
• Sets the IR receiver to its default condition (disabled)
• Sets all input audio gain levels to their default values
-12 dB for captive screw audio connector (A) models
0 dB for RCA audio connector (A RCA) models
I / O
I/O
AUD
VID
I/O
AUD
VID
Press and hold the I/O button while
you apply power to the switcher.
Power
I/O
AUD
AUDIO SETUP
PRESET
VID
+dB
- dB
1
1
The switcher lights
all of the LEDs.
The switcher continues the power up process.
Release the I/O button.
Figure 3-43 — System reset to factory defaults
Memory
The current configuration, all presets, and all input audio levels are saved in non-
volatile memory within 5 seconds of a change or exiting Audio Setup mode. When
power is applied, the last current configuration is retrieved. The previous presets
remain intact.
Wait at least 5 seconds after changing any configuration, saving a preset, or
exiting Audio Setup mode. Before 5 seconds have elapsed, changes that you
have made may not have been saved.
Summary of Contents for MAV 44 Series
