FOXBOX Tx/Rx HDMI • Remote Control
18
Remote Control
This section includes:
•
Simple Instruction Set Control
•
The transmitter and receiver each have a front panel Configuration port,
a 2.5 mm mini
stereo jack (see
Front panel Configuration ports
on page 14). The receiver has a rear
panel Remote RS-232 port, a 3-pole captive screw connector (see
on page 13). Any of these ports can be connected to a host device such as a computer
running the HyperTerminal or DataViewer utility, or a control system to make serial control of
the transmitter and receiver possible.
The default serial port protocol for all ports is as follows:
•
9600 baud
•
No parity
•
8-bit
•
No flow control
•
1 stop bit
NOTE:
RS-232 commands and FOX Extenders Control Program functions are
transmitter- or receiver-specific or may have different responses depending on the unit
connected. You must connect to the appropriate device for the command or function
to work properly or to get the expected response.
Simple Instruction Set Control
Host-to-Unit Communications
SIS commands consist of one or more characters per field. No special characters are
required to begin or end a command character sequence. When a command is valid, the
switcher executes the command and sends a response to the host device. All responses
from the transmitter or receiver to the host end with a carriage return and a line feed
(CR/LF =
]
), which signals the end of the response character string. A string is one or
more characters.
Summary of Contents for FOXBOX Rx HDMI
Page 6: ......
