FOXBOX Tx / Rx • Remote Control
33
Audio Output Level radio buttons
— Click either the
Consumer
Level
(-10 dBV)
(see
on the previous page,
7
) or
Professional
Level
(+4 dBu)
(
) radio button
to select the output audio level.
NOTE:
When you make an audio output level change, the setting is changed in the
receiver. It reports the changes to the transmitter via the optional receiver-Tx-to-
transmitter-Rx cable.
If the PC is connected to the transmitter
and
either
the
receiver-Tx-to-transmitter-Rx cable is not connected in
your system
or
the receiver is in the daisy chain mode, the
program cannot report the output audio level in the Audio
Adjustment panel. You can change the level, but the
program cannot report the changes. The program shows
the
Set
Consumer
(or
Set
Professional
) level message
to indicate that the output level command is control
only, not an indication (see figure 19). The message is
displayed for approximately 1 second.
Figure 19.
Alternate
Audio Adjustment
Panel Indication
Memory Preset panel
The
Memory
Preset
panel provides a means to save and recall memory presets. Memory
presets are stored values of the horizontal and vertical position and sizing information saved
in nonvolatile memory. When the FOXBOX unit is powered down and later powered back
up, the settings are available for selection using the
Recall
). Saving the settings
to a preset using the
Save
) overwrites the settings previously written to that
preset.
Mute panel
Click the
Video
Mute
(
£
) radio button, the
Audio
Mute
radio button (
¤
), or both in the
Mute
panel to turn the video and audio mutes on and off.
NOTES
:
•
When the video output is RGB and the output is muted,the receiver mutes the
red, green, and blue planes, but leaves the sync plane(s) (horizontal and vertical or
composite sync) live so that there is no loss of sync in the display device.
•
When you mute or unmute the output, the setting is
changed in the receiver. It reports the changes to the
transmitter via the optional receiver-Tx-to-transmitter-
Rx cable.
If you are connected to the transmitter
and
either
the
receiver-Tx-to-transmitter-Rx cable is not connected in
your system
or
the receiver is in the daisy chain mode,
you can still mute the output in the
Mute
panel, but the
program cannot report the position values. The
Set
video
(or
audio
)
mute
On
or
Off
message is displayed
for approximately 1 second (figure 20).
Figure 20.
Alternate
Mute Panel Indication
Summary of Contents for FOXBOX Rx DVI MM
Page 6: ......
Page 8: ...FOXBOX Tx Rx Contents viii...