Extron electronics FOX3 SR 20, User Manual

Page: 20 / 56

FOX3 SR 201 Scaling Receiver • Operation 12
Operation
This section details the operation of the FOX3 SR 201 scaling receiver, including:
•
Front Panel Features
• Operations
• Using the On-Screen Menu System
• Reset Modes
•
Front Panel Lockout (Executive Mode)
• Configuration
• Audio Configuration
Front Panel Features
FOX3 SR 201
MENU
CONFIG
INPUT
SIGNAL
HDCP
ENTER
C C C A A A D D D E E E B B B
Figure 8. FOX3 Scaling Receiver Front Panel Features
A
Power LED — Lights when the unit is receiving power and is operational.
B
Configuration port — This USB mini-B port is used to configure the unit and to
update firmware.
C
Input LEDs
•
Signal LED
— Lights when the unit detects an input video signal.
• HDCP LED — Lights when the input signal is HDCP encrypted.
D
Menu and Enter buttons — Press these buttons to access and navigate the on-
screen display menu system.
E
Navigation buttons — Press these buttons to navigate through the on-screen display
menu system or change settings.
Operations
After the transmitter, receiver, and the connected devices are powered up, the system is fully
operational. If any problems are encountered, ensure all cables are routed and connected
properly.
NOTE: Ensure that the video source and display are properly connected to the FOX3
transmitter and receiver, and power is applied to the FOX3 devices and the display
before power is applied to the video source. If the other devices are not turned on
before the video source, the image may not appear.
Configuration and operation of the system is accomplished via SIS Configuration and
Control (see page 21), the Internal Web Page (see page 40), and Configuration
Software (see page 31).
8