Extron electronics FOX3 SR 20, User Manual, Page: 21 / 56

FOX3 SR 201 Scaling Receiver • Operation 13
Using the On-Screen Menu System
The OSD menus are used primarily for the initial setup of the device. The on-screen menu
presents configuration options on a local monitor and can be adjusted with front panel
controls.
NOTE: The on-screen menu has a default timeout of 60 seconds.
Menu Selection Buttons
• Menu button — Press the Menu button (see
figure 9,
1
) to activate or exit the on-screen menu,
deselect a submenu, or cancel a pending change.
• Enter button — Press the Enter button (
2
) to
access the on-screen menu, select submenus,
submenu items, or to accept pending changes.
•
Navigation buttons — Press these buttons to
navigate through the menu system:
FOX3 SR 301
CONFIG
INPUTS
SIGNAL
HDCP
USB HID
USB 2.0
USB
1 2
MENU
ENTER
HOST
F
2 2 2
1 1 1
3 3 3
5 5 5
4 4 4
6 6 6
Figure 9. Menu Selection
Buttons
• Press the

( Up ) (
3
) or the

( Down ) (
4
) arrow button to navigate submenus or
submenu items.
• Press the  ( Left ) arrow button (
5
) to access currently selected submenus or
submenu items.
• Press the  ( Right ) (
6
) arrow button to exit currently selected submenus or
submenu items.
Also use the navigation buttons to adjust settings according to specific setting
directions.
Menu Overview
In the on-screen menu, the product name is displayed at the top of the right column. The
active input and output resolutions are displayed in the bottom border. The on-screen menu
contains two submenus with various adjustable settings or device information (see the
Submenus table).
Submenus Device Info Quick Setup
Submenu Items Unit Name Output Rate
Firmware HDMI Format
Temperature Test Pattern
Input Factory Reset
Format
Signal
HDCP
Output
Format
Display
HDCP
9