Extron electronics FOX3 SR 20, User Manual, Page: 24 / 56

FOX3 SR 201 Scaling Receiver • Operation 16
• HDMI Format — After selecting HDMI Format press the

or

buttons to select the
output format. The format choices include:
• Auto (based on the EDID of the sink) (default)
• DVI RGB 444 (no audio, no Infoframe)
•
HDMI RGB 444 Full
• HDMI RGB 444 Limited
• HDMI YUV 444 Full
• HDMI YUV 444 Limited
•
HDMI YUV 422 Full
• HDMI YUV 422 Limited
• Test Pattern — Press the navigation buttons to select an available test pattern to
display or to turn a test pattern off. The available test pattern selections are Crop ,
Alternating Pixels , Crosshatch , Color Bars , and Grayscale 32 Level . The
default setting is Off.
Figure 13. Test Patterns
•
Factory Reset — Resets the unit to its factory default values (removing any user-
specified values) while retaining all TCP/IP settings.
To reset using the OSD menu, press and hold the
Enter button until Factory Reset is
displayed (approximately 5 seconds). The message remains for approximately 1 minute
after the reset is complete to allow time for the display device to sync with the FOX3
output.
Reset Modes
The rear panel Reset button initiates three levels of resets (numbered 1, 4, and 5). Use a
pointed stylus, ballpoint pen, or small screwdriver to access the recessed button.
See the
Reset Modes table and figure 14 on page 17 for a summary of the resets.
ATTENTION:
• Review the reset modes carefully. Some reset modes delete all user loaded content
and revert the device to default configuration.
• Analysez minutieusement les différents modes de réinitialisation. Certains modes de
réinitialisation suppriment l’intégralité du contenu chargé de l’utilisateur et remettent
l’appareil au mode de configuration par défaut.
13