FOX3 SR 201 Scaling Receiver • Operation
17
Perform resets of the unit as follows:
RESET
RESET
RESET
RESET
RESET
RESET
RESET
RESET
Press and
hold
the Reset button.
Mode 1
Apply power
to the FOX3.
Release Reset button.
Release, then
immediately
press and release again.
Reset LED flashes, then stays on.
Mode 4
Reset LED flashes
twice
.
Press and
hold
for 6 seconds.
Release, then
immediately
press and release again.
Reset LED flashes, then stays on.
Mode 5
Reset LED flashes
three
times
.
Press and
hold
for 9 seconds.
Figure 14.
Resets
Reset Modes
Mode
Activation
Result
Purpose and Notes
Use Factory Firmwar
e
1
Hold in the recessed rear panel
Reset
button while applying
power.
The device reverts to the factory default
firmware for a single power cycle.
Use to revert to the factory default
firmware for a single power cycle if
incompatibility issues arise with user-
loaded firmware. All user files and
settings are maintained.
NOTE:
Do not operate with the default firmware loaded by a mode 1 reset. Use it only to load the most current
firmware to the device.
Reset IP Setting
*4
Hold in the
Reset
button about
6 seconds until the
Power
LED
blinks twice. Then, release
and press the
Reset
button
momentarily (<1 second) again
within 1 second.
Sets the following back to factory default:
•
Port mapping
•
IP address:
192.168.254.254
•
Subnet mask address:
255.255.255.0
•
Gateway address:
0.0.0.0
Turns DHCP off.
Power
LED blinks 4 times during reset.
Use to reset all IP settings back to
the factory defaults.
Equivalent to SIS command
1Z
QQQ.
Reset to Factory Default
*5
Hold in the
Reset
button until
the
Power
LED blinks three times
(once at 3 seconds, again at
6 seconds, again at 9 seconds).
Then, release and press the
Reset
button again within
1 second
*
.
A complete reset to factory defaults
(except the firmware).
•
Does everything mode 4 does.
•
Clears port configurations.
•
Resets all IP options.
•
Clears all user settings.
•
Clears all files from the unit.
•
Power
LED blinks four times.
Mode 5 is useful to start over with
default configuration and uploading,
and also to replace events.
Mode 5 is equivalent to SIS
command
Z
QQQ.
NOTES:
•
*For modes 4 and 5, nothing happens if the momentary press does not occur within 1 second.
•
The factory configured passwords for all accounts on this device have been set to the device serial
number. In the event of a complete system reset, the passwords convert to the default, which is
extron
.
14
Summary of Contents for FOX3 SR 20
Page 2: ...Safety Instructions...
Page 6: ......