4-3
IPL T PCS4 • Web Page-Based Setup and Control
PRELIMINAR
Y
ARP-S command screen
After the
arp -s
command is issued, the PCS4 changes to
the new address and starts responding to
ping
requests, as
described in the next step.
5
.
To verify that the new address has been set, execute a
ping
command by
entering “ping,” followed by the new IP address, at the command prompt.
Ping
is a utility or diagnostic tool that tests network connections. It is used
to determine if the host has an operating connection and is able to exchange
information with another host.
Example:
ping 10.13.170.15
The response should be the PCS4’s new IP address, as shown below.
Screen showing the Ping command
You can reconnect using either Telnet or a Web browser to verify that the
update was successful.
6
.
After verifying that the IP address change was successful, issue the
arp -d
command at the DOS prompt to remove the address from the ARP table. For
example:
arp -d 10.13.170.15
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
