Extron electronics DVC RGB-HD A, User Manual

Page: 10 / 41

DVC RGB-HD A • Installation 3
Installation
This section gives the steps for installing the DVC RGB-HD A. It also provides a description
of the rear panel connectors and instructions for cabling. Topics include:
•
Installation Overview
• Front and Rear Panel Features
• Wiring the Power Connector
• Securing the HDMI Connector Using the LockIt Cable Lacing Bracket
•
Connecting for USB Control
• EDID Minder
Installation Overview
ATTENTION:
• Installation and service must be performed by authorized personnel only.
•
L’installation et l’entretien doivent être effectués par le personnel autorisé
uniquement.
Follow these steps to install and set up the DVC RGB-HD A :
1. Disconnect power
from the converter and ensure that all other devices that will be
connected to it are powered off.
2. (Optional) Mount the unit in a rack or to furniture (see Mounting , beginning on
page 32).
3. Connect the input. Connect an RGBHV source to the front panel VGA input
connector (see figure 2 ,
B
, on the next page).
4. (Optional) Connect the audio input. Connect analog audio to the 3.5 mm TRS jack on
the front panel (see figure 2 ,
C
).
5. Connect the digital output. Connect an HDMI sink to the rear panel HDMI output
connector (see figure 3 ,
B
, on page 5).
6. Connect a control device. Connect a computer or control system to the rear panel
USB Config port (see figure 3 ,
C
) to configure and control the converter via SIS
commands or the PCS Configuration Software.
7. Connect a 12 VDC power supply to the 2-pole captive screw power connector (see
figure 3 ,
A
).
NOTE:
The 12 VDC power supply is not included, but can be ordered at
www.extron.com .
8. Configure the DVC RGB-HD A as needed, using SIS commands (see the Remote
Configuration and Control section, beginning on page 11) or the PCS software (see
the program help file).