PMK 350 mounting
Mount the receiver to a PMK 350 bracket as follows:
1.
Remove the front and rear plates from the PMK 350 (figure 8), using an Extron
Tweeker or
a #2 Phillips screwdriver
. Retain the screws to reattach the plates.
Extron
PMK 350
Multi-product Pole
Mount Kit
Cover Sheet
Front Plate
Rear Plate
U-bolt
L-shaped
Bracket
Contoured
Base
Extron
Power Supply
Extron
Quarter-rack
Sized Product
Figure 8.
PMK 350 Projector Mounting a Receiver
2.
If necessary, remove the feet from the bottom of the receiver.
3.
Secure the receiver to one side of the mounting tray, using two of the supplied
4-40 x 3/16-inch screws in opposite (diagonal) corners.
4.
If power supply is connected to the receiver, use the two included tie wraps to strap
the power supply to the bracket.
5.
Place the PMK 350 around the projector ceiling mounting pole (figure 8).
6.
Assemble the U-bolt and the following parts in the following order (figure 9):
a.
Pass the legs of the U-bolt through the slotted holes on the mount plate flange.
b.
Place the legs around the projector pole.
c.
Pass the legs through the holes in the contour base.
NOTE:
The pole fits snugly into the depression in the center of the contoured
base.
d.
Pass the legs through the holes in the L-shaped bracket.
NOTE:
The supplied U-bolt fits a typical (1.5-inch to 2.0-inch diameter) ceiling
pole.
U-bolt
Slotted Hole
in PMK Tray
L-shaped
Bracket
L-shaped
Bracket Screws
Contoured
Base
Ceiling
Pole
Mount Plate
Flange
Figure 9.
Hanging the Tray on the Pole
HDMI 201 • Installation and Operation
11
