Extreme Networks Summit Summit1i, Hardware Installation Manual

Page: 51 / 65

Summit Switch Hardware Installation Guide 2-9
Installing the Gigabit Interface Connector (GBIC)
Note: After two incorrect login attempts, the Summit switch locks you out of the
login facility. You must wait a few minutes before attempting to log in again.
Installing the Gigabit Interface Connector (GBIC)
GBICs can be added and removed from the switch without powering off the system.
The two types of GBIC modules are shown in Figure 2-5.
Figure 2-5: GBIC modules
GBICs are a Class 1 laser device. Use only Extreme-approved devices.
Note: Ensure that the SC fiber-optic connector is removed from the GBIC prior to
removing the GBIC from the I/O module.
Caution: Invisible laser radiation can occur when open. Avoid direct eye
exposure to beam.
To remove the GBIC module labeled “Module A,” lift up on the front handle and pull
the GBIC out of the slot.
To remove the GBIC module labeled “Module B,” gently squeeze the sides to release it,
and pull the GBIC out of the slot.
To insert a GBIC module, follow these steps:
1 Holding the GBIC by its sides, insert the GBIC into the slot on the I/O module.
2 Slide the GBIC as far back into the slot as possible, until you hear it click.
3 If the GBIC has a handle, push down on the handle to secure the GBIC in the slot.
EW_GBIC
Module A Module B