1 Use appropriate antistatic protection when handling power supplies.
2 If a power cord retention clip is securing the power cord, push down on the retention clip clamp tab
to open the clamp and disengage the power cord from the clamp.
3 Unplug the associated power cord from the AC inlet.
4 Remove the power supply by simultaneously pressing the power supply lock tab to the left, grasping
the handle, and pulling the power supply straight out of the SSA switch.
See
Figure 19: Removing the Power Supply
1 = Lock tab
2 = Power supply handle
5 If you are removing the power supply from power supply bay PS2, and you are not immediately
installing another power supply, reinstall the coverplate that comes with the SSA switch over the
empty PS2 power supply bay.
Caution
If you plan to operate the chassis with only one power supply, the power supply must be
installed in the left power slot labeled PS1 and the coverplate must be in place in the right
power slot to contain EMI radiation and ensure proper air circulation.
Precaución: Si desea trabajar sólo con una fuente de poder, no olvide colocar la tapa en el
compartimiento de la fuente de poder que haya eliminado, para reducir la interferencia
electromagnética y para asegurar una buena ventilación.
Troubleshooting
S-Series Stand Alone (SSA) Switch Hardware Installation Guide
41
