When the initialization process is successful, the CPU LED turns green. If the CPU LED does not turn
green, refer to
on page 34.
Installing the Power Cord Retention Clip Assembly
The SSA switch comes with two optional power cord retention clip assemblies. Power cord retention
clips provide added security against the inadvertent removal of the power cord from the power supply
AC receptacle.
To install the power cord retention clip assembly, follow these steps:
1 Holding the strap piece with the rough side facing away from the power supply, shown by callout 2
of
on page 26, insert the strap piece into the hole to the right of the power cord
receptacle, shown by callout 1.
2 Slide the power cable clamp, shown by callout 3, onto the strap piece with the tab on the clamp
piece facing out.
3 Insert the power cord in the open clamp.
4 Close the clamp piece.
To open the clamp piece, push down the clamp release tab, shown by callout 4.
Figure 13: Installing the Power Cord Clip Assembly in the Power Supply
1 = Retention clip receptacle
3 = Power cable clamp
2 = Retention clip strap piece, smooth side facing
power supply
4 = Clamp release tab
Installation
S-Series Stand Alone (SSA) Switch Hardware Installation Guide
26
