ro
Read-Only access
rw
Read-Write access
admin
Super-user access to all modifiable parameters
The default password for all three accounts is set to blank (null). For information on changing these
default passwords, refer to the
S-, K-, and 7100 Series Configuration Guide
.
1 Connect a terminal to the local console port as described in
Connecting to a Local Management
The startup screen displays.
login: admin
Password:
SSA
Command Line Interface
Extreme Networks, Inc.
145 Rio Robles
San Jose, CA 95134 USA
Phone: +1 800 998 2408
E-mail: [email protected]
WWW: http://www.extremenetworks.com
(c) Copyright Extreme Networks, Inc. 2016
Chassis Serial Number: xxxxxxxxxxxx
Chassis Firmware Revision: xx.xx.xx.xxxxT
User admin last logged in WED SEP 14 16:12:42 2016
There have been 0 failed login attempts since then
SSA(su)->
2 At the login prompt, enter one of the following default user names:
•
ro
for Read-Only access
•
rw
for Read-Write access
•
admin
for Super User access. (This access level allows read-write access to all modifiable
parameters, including user accounts.)
3 Press
Enter
.
4 The Password prompt displays. Leave this string blank and press
Enter
.
The device information and SSA switch prompt appear as shown in step
on page 33.
The SSA switch is now ready to be configured. The CLI commands enable you to initially set up and
perform more involved management configurations.
For information about setting the IP address and configuring Telnet settings for remote access to SSA
switch management, refer to the
S-, K-, and 7100 Series Configuration Guide
Installation
S-Series Stand Alone (SSA) Switch Hardware Installation Guide
33
