Extreme Networks ExtremeSwitching VDX 6740, Hardware Installation Manual

Page: 58 / 135

NOTE
Not all parts may be used with certain installations depending on the device type.
NOTE
Although this document describes how to install both single height (1U) and double height (2U) devices, the illustrations show a
2U device as a typical installation.
Attaching the front brackets to the device
CAUTION
The device must be turned off and disconnected from the fabric during this
procedure.
Complete the following steps to attach the front brackets to the device.
1. Position the right front bracket with the flat side against the right side of the device as shown in the following figure.
2. Insert two 8-32 x 5/16-in. screws through the pair of vertically aligned holes in the bracket and then into the pair of holes on
the side of the device.
3. Insert another 8-32 x 5/16-in. screw through the third hole in the bracket and into the corresponding hole in the device.
4. Repeat step 1 through step 3 to attach the left front bracket to the left side of the device. Tighten all 8-32 x 5/16-in. screws to
a torque of 15 in-lbs. (17 cm-kgs).
FIGURE 37 Attaching the front brackets
1. Front brackets, right and left 2. Screw, 8-32 x 5/16-in., panhead Phillips
Installing the 1U and 2U Flush-Mount Rack Kit for Two-Post Racks (XBR-000307 and XBR-R000293)
ExtremeSwitching VDX 6740 Hardware Installation Guide
58 9036108-00