Extreme Networks ExtremeSwitching VDX 6740, Hardware Installation Manual

Page: 34 / 135

CAUTION
The device must be turned off and disconnected from the fabric during this
procedure.
Complete the following steps to install the device in the rack.
NOTE
Hardware devices illustrated in these procedures are only for reference and may not depict the device you are installing into the
rack.
1. Position the device in the rack as shown in the following figure, providing temporary support under the device until the rail kit is
secured to the rack.
2. Attach the right front bracket to the right front rack post using two 10-32 x 5/8 in. screws and two retainer nuts.
3. Repeat step 2 to attach the left front bracket to the left front rack post and tighten all 10-32 x 5/8 in. screws to a torque of 25
in-lb (29 cm-kg).
FIGURE 16 Position the device in the rack
1. Bracket, front right
2. Bracket, front left
3. Screw, 10-32 x 5/8 in., panhead Phillips
4. Retainer nut, 10-32, square or round hole as needed
Attaching the rear brackets to the front brackets
Complete the following steps to attach the rear brackets to the front brackets.
NOTE
Hardware devices illustrated in these procedures are only for reference and may not depict the device you are installing into the
rack.
1. Position the right rear bracket inside the right front bracket as shown in the following figure.
2. Attach the brackets using four 6-32 x 1/4 in. screws.
3. Adjust the brackets to rack depth and tighten the screws to a torque of 9 in-lb (10 cm-kg).
Installing the 1U Slim Rail Rack Mount Kit for Four-Post Racks (XBR-000291)
ExtremeSwitching VDX 6740 Hardware Installation Guide
34 9036108-00