Installing an RPS-150XT on a Flat Surface
Caution
Observe all Electrostatic Discharge (ESD) precautions when handling sensitive electronic
equipment.
When installing the RPS-150XT power supply on a flat surface, we recommend installing the rubber feet
to prevent the power supply from sliding.
Note
Do not install the rubber feet on the power supply if you are installing the power supply in the
three-slot modular shelf (STK-RPS-1005CH3).
To prepare the RPS-150XT for use on a flat surface, follow these steps.
1 On a sturdy flat surface, lay the power supply on its top.
2 Remove the four rubber feet from their plastic bag in the shipping box.
3 Remove the protective strip from the back of one rubber foot and position it on a bottom corner of
the power supply.
Press the rubber foot firmly into place.
Repeat this step for each of the remaining three rubber feet.
4 After installing the rubber feet, return the power supply to its upright position.
5 Connect the RPS-150XT to its power source.
Connecting the RPS Cable and AC Power Cord to an RPS-150XT
on page 30.
Connecting the RPS Cable and AC Power Cord to an RPS-150XT
The RPS-150XT power supply is connected to the switch using the supplied RPS cable, as follows.
Caution
Observe all Electrostatic Discharge (ESD) precautions when handling sensitive electronic
equipment.
1 Connect one end of the RPS cable to the Redundant Power Supply connector on the switch.
2 Connect the other end of the RPS cable to the Redundant Power Supply connector at the rear of the
power supply.
See
.
External Power Supplies
ExtremeSwitching 210 and 220 Series Switches: Hardware Installation Guide
30
