Extreme Networks BlackDiamond 8806, Hardware Installation Manual

Page: 36 / 200

BlackDiamond 8000 Series Modules
BlackDiamond 8800 Series Switches Hardware Installation Guide
36
10G4Ca I/O Module
The 10G4Ca I/O module ( Figure 18 ) has four 10-gigabit Ethernet ports that use CX4 interface
connectors.
Figure 19: 10G4Ca I/O Module
In the default configuration of the 10G4Ca I/O module, all ports:
●
Are added to the default VLAN as untagged
●
Inherit the properties of the default VLAN (for example, protocol type and VLANid)
The 10G4Ca I/O module has the following LEDs:
●
Module status
●
Module diagnostics
●
Port status
For information about the LEDs and their activity on the 10G4Ca I/O module, see “I/O Module LEDs”
on page 50 .
BlackDiamond 8800 c-Series I/O Modules
The BlackDiamond 8800 c-series of I/O modules consists of the following:
●
G48Tc I/O Module on page 37
●
10G4Xc I/O Module on page 38
●
10G8Xc I/O Module on page 39
●
G24Xc I/O Module on page 40
●
G48Xc I/O Module on page 41
CAUTION
ExtremeXOS builds earlier than version 12.1 do not support the BlackDiamond 8800 c-series modules. If you
attempt to install one of these I/O modules before upgrading the software on your MSM the module will not be
recognized by the software and it will not power up. The following error messages are similar to the messages that
may be displayed on the console or in the log. (Samples represent an unrecognized module in slot 2.)
●
Console: ERROR: Unknown cardtype in slot 2 - please program the eeprom
●
Log: <Error: HAL.Card.Error> MSM-A: Unable to read cardtype for slot 2
10G4Ca 10G4Ca
10GBASE-CX4
41613
Module status LEDs 10 Gbs ports
BD_156