Basic Configuration
AP-7622 Access Point Installation Guide
16
If logging in using a factory default configuration, Startup Assist automatically displays.
If Startup Assist does not automatically display, it can be invoked at any time from the
upper-left of the
Basic Configuration
screen.
6 Set the following Startup Assist parameters:
•
Virtual Controller
- Sets this Access Point as a Virtual Controller capable of managing
and provisioning up to 24 Access Points of the same model. Access Points managed
by this Virtual Controller list this Access Point's AP Name as its own. Only one Virtual
Controller can be designated.
•
Country Name
- Set the country specific to this AP-7622's deployment location.
Selecting the correct country is central to legal operation. Each country has its own
NOTE
Startup Assist automatically sets the radio transmit power and enables Auto
Channel selection. The Access Point's name is automatically assigned based on
the Access Point type and the last three octets of the device's hard coded MAC
address. WLAN 1 and WLAN 2 both use VLAN ID 2200 by default. To adjust
any of these parameters, edit the appropriate configuration screen directly.
Refer to the Access Point reference material available on Extreme Networks
support site for configuring the Access Point beyond the scope of the minimal
WiNG Assist configuration described in this guide.
