Hardware Installation
AP-7622 Access Point Installation Guide
8
•
The Power Injector isn’t a repeater, and does not amplify the Ethernet signal. For optimal
performance, ensure the Power Injector is placed as close as possible to the data port.
To install the Power Injector to an Ethernet data source and an Access Point:
1
Connect the Power Injector to an AC outlet (100VAC to 240VAC).
2 Connect an RJ-45 Ethernet cable between the Power Injector
Data & Power Out
connector and the Access Point’s GE1/POE port.
3 Connect an RJ-45 Ethernet cable between the network data supply (host) and the
Power Injector
Data In
connector.
Ensure the cable length from the Ethernet source (host) to the Power Injector and
Access Point does not exceed 100 meters (333 ft).
The Power Injector has no On/Off power switch. The Injector receives power and is
ready for device connection and operation as soon as AC power is applied. Refer to the
Installation Guide shipped with the Power Injector for a description of its LEDs.
Mounting Instructions
An AP-7622 can be mounted to a flat wall surface or on a T-Bar of a suspended ceiling.
Wall Mount Procedure
To wall mount an AP-7622 model Access Point:
CAUTION
To avoid problematic performance and restarts, disable POE from a wired
switch port connected to an Access Point if mid-span power sourcing
equipment (PSE) is used between the two, regardless of the manufacturer of
the switch.
CAUTION
Ensure AC power is supplied to the Power Injector using an AC cable with an
appropriate ground connection approved for the country of operation.
NOTE
Before wall mounting the AP-7622, obtain the unit’s default IP address from the
backside of the unit. This default IP address is needed when connecting to the
Access Point.
