Extreme Home Arcades Classic series, Operation Manual

Page: 61 / 86

F.A.Q. QUESTIONS CONTINUED…
1. Nintendo Ds Loaded several Games, all seem to load fine and work using the Trackball (and upper left
Trackball Button) to write on the lower screen, normal buttons used for D-Pad and Buttons
2. Nintendo 64 Any errors are due to the game not extracting in time to load. If you get a timeout error (yellow
!) do an ALT+TAB and close the N64 Emulator out and load that game again. It will work the 2nd time and
every time after this as it is then loaded into High Memory permanently...
3. Nintendo 64 Disk Drive There are only a few games (one being "Doshin the Giant") that work on this
system... This will be improved over time.
4.Playstation 2 PlayStation 1 and 2 take a while to initially load the disk images (they must be extracted first),
some take a minute some can take up to 5 minutes to extract but once they are extracted on your system they
will load almost instantly everytime you load them after the 1st initial load. We have a few titles that do not
load or have poor emulation but this system is huge and with time will improve. PS2 is our newest emulation
system and is being updated constantly. Remember, all N64, PS1, PS2, Gamecube,and PSP games require the
Wireless Analog Controllers, they must remain ON till the game is fully loaded or the system will not "see"
them.
5.TAITO type X All games tested work perfectly... remember this is an Arcade Emulation System so it requires
Credits (player 1 start + Player 1's first button)
6. DosBox When the game first loads you have to select one of the 3 ICONs on the screen (select "Single
Player" for normal play), this select button is Either Player 1's Start Button OR Player 3's 3rd Button (Enter) or
you can send an "Enter" command by Holding Player 1's start button and pushing LEFT on Player 1's
Joystick. Then the game will start, you can use the normal controls and Trackball and upper left trackball
button to select things - PC Games
7. ScummVm Most of these games work fine, you have to use the trackball and upper left trackball button to
select, point and click PC games.
8. Atari 2600 There is no "Reset" Button Set on your machine for this system... Hold Player 1's Start Button
and push RIGHT on Player 1's Joystick, this will bring up the Menu. Select "Input" and then assign Player 1's
start button to "RESET" by clicking on the "MAP" icon. Return to Game and Play.
9. Atari 5200 Most games tested worked fine... Remember you can easily config all controls with this system by
bringing up the In Game Menu (player 1's Start + Player 1 Joystick RIGHT) and select "Input This System"
10. Atari 7800 Most games tested worked fine... Remember you can easily config all controls with this system by
bringing up the In Game Menu (player 1's Start + Player 1 Joystick RIGHT) and select "Input This System"
61 | P a g e