Extraflame SHARON PLUS, User Manual

Page: 29 / 40

29 ENGLISH
Š
RESEt
The setting allows you to reset the Wi-Fi to factory settings
To set: OK > SeTTINgS > WI-FI > reSeT > OK
Š
inFo
Three pieces of information about the Wi-Fi function are available in this menu. This information may be requested by the app during the
configuration stage.
To set: OK > SeTTINgS > WI-FI > INFO
- MAc: unique identification code of the Wi-Fi device
- code: numeric code required for connection with the extraflame server
- RSSI: Received signal strength, when the Wi-Fi is correctly connected to an access point
The rSSI value is expressed in decibels (db) as a negative number which is typically in the range between -60db (excellent signal) and -85db (very
poor signal). If the signal is poor, we recommend purchasing a Wi-Fi repeater to avoid any connectivity problems.
OperatIOn and sOlUtIOns
The Wi-Fi module identifies the operation status using the green “Wi-Fi” led. The table below shows how to interpret the information provided
and the solutions to implement
Wi-Fi LED StatuS EXPLanation SoLution
oFF Module off
enable the module from the Wi-Fi menu
check the stove power supply
contact the technical support service
FAST on/oFF FlASHIng
(0.1s on / 0.1s oFF)
Stove not recognised
Connection problem with the main stove card
It is correct for the stove not to be recognised in
the first few seconds after being switched on
If the status persists, contact the technical
support service
2s on / 2s oFF
Access point
The module is ready to be configured from the app
Follow the App manual to complete the
configuration
1s on / 1s oFF
connection in progress
The module is attempting to make the connection
to the home network selected.
The module may take up to one minute to
make the connection. If the problem persists,
run a reset and reconfigure the product
0.5s on / 0.5s oFF Wi-Fi network connection but no server access
check that for the internet connection to the
selected Wi-Fi network.
check that the data entered in the App are
correct.
If the status persists, contact the technical
support service
2 flashes / 4 s
connected to the server, but product
configuration problem
contact the technical support service
on The product is connected to the server
To disable the connection, use the enABle
menu
0.1s on / 0.3s oFF The module is updating
The process will be automatically completed in
a few minutes
If the status persists, contact the technical
support service