Extraflame SHARON PLUS, User Manual

Page: 28 / 40

28 ENGLISH
delta-t
This function allows the hysteresis thresholds to be set for stove ignition (delTA T on) and switch-off (delTA T oFF), used as a room
temperature adjustment interval if not managed by an external thermostat .
The possible values of DeLTa-T vary between: 0.5 - 5°C
To set: OK > SeTTINgS > DeLTa-T
FIrst lOad
This function allows you to activate the gearmotor for continuous pellet feeding.
Before starting the function, make sure the stove is cold and “oFF”.
To set: OK > SeTTINgS > FIrST LOaD
To stop continuous loading, just press and hold the
OK
key for 2”.
QuIcK AcceSS:
Before starting the function, make sure the stove is cold and “oFF”.
press keys
OK
+ at the same time for two seconds until the message “FIRST loAd” is displayed.
To stop continuous loading, just press and hold the
OK
key for 2”.
reset
Allows the user to reset all editable values to the default values.
To set: OK > SeTTINgS > reSeT.
easy cOntrOl
The function allows for two values to be set:
Š
oFF (disabled - factory default)
Š
on (enabled)
Activation (eASY conTRol = on) is recommended if there is an excessive formation of combustion residues in the flue during operation at
reduced power (see Flue eXHAuST chapter).
caution! It is advisable to activate the easy cOntrOl function under the supervision of a qualified technician.
To set: OK > SeTTINgS > eaSy CONTrOL
wI-FI
Allows you to change the settings for the Wi-Fi module integrated in the emergency console.
The stove is fitted with an integrated Wi-Fi module in the emergency console and has a “Wi-Fi” led dedicated specifically to monitoring and
troubleshooting the Wi-Fi function.
The entire Wi-Fi interface is grouped under the Settings -> W-Fi menu
There are no physical keys connected to the Wi-Fi module, enABlIng and ReSeT are performed using the remote control via the boiler card.
The configuration must be entered using the Total control 2.0 App. For instructions, consult the website:
https://www.lanordica-extraflame.com/sites/default/files/documenti_temp/004281060-000_istr.app_total_control_2.0.pdf
Š
EnaBLinG
The integrated Wi-Fi can be enabled and disabled. When the Wi-Fi is disabled, the connection settings are store and it is no necessary to enter
a new configuration when it is turned on again.
To set: OK > SeTTINgS > WI-FI > eNabLINg> ON/OFF