Extraflame GLENDA WIFI, User Manual

Page: 19 / 32

ENGLISH
sTBy FUNCTiON seT aT OFF (DeFaUlT seTTiNg)
if the stby function is not active (OFF), if the stove reaches the set room temperature, it will go to minimum, modulating and displaying
modulate. When the room temperature is below the setting, it will start to work again at the set power and displaying work.
Delta t oFF
The function allows for the setting of DelTa T OFF.
CONTrOls prOCeDUre
Š
press key 6 and set power will appear.
Š
press key 2 several times until settings is displayed.
Š
press key 6.
Š press key 2 until DelTa T OFF is shown and use key 6 to confirm.
Š
Use keys 4-5 to set the DelTa T OFF (OFF - 0.5 - 5.5°C)
Š
press key 1 several times to confirm and exit the menu.
Delta t on
The function allows for the setting of DelTa T ON.
CONTrOls prOCeDUre
Š press key 6 and set power will appear
Š
press key 2 several times until settings is displayed.
Š
press key 6.
Š
press key 2 until DelTa T ON is shown and use key 6 to confirm.
Š Use keys 4-5 to set the DelTa T ON (OFF - 0.5 - 5.5°C)
Š
press key 1 several times to confirm and exit the menu.
stanD-By with aDDitional thermostat
The stBy function is used if immediate stove switch-off is required when the set temperature has been reached.
By default, the stBy function is always set to oFF (indicator
on).
stBy FunCtion set to oFF (FaCTOry seTTiNg)
should the sTBy function not be active (OFF), if the stove reaches the room temperature set on the additional thermostat (contact open), it
will go to minimum, modulating and displaying
moDulate
. When the room temperature is below the setting on the additional thermostat
(contact closed), it will start to work again at the set power displaying
work
.
stBy FunCtion set to on
When the sTBy function is activated (ON), the stove, upon reaching the set room temperature and exceeding it by 2°C, will switch off after a
pre-set default delay, displaying stanD-By.
When the room temperature is below the setting on the additional thermostat, it will start to work again at the set power displaying
work
CONTrOls prOCeDUre
Š
press key 6 and set CloCk will appear.
Š
press key 2 several times to reach set user.
Š Confirm using key 6.
Š
press key 2 several times to reach stanD-By.
Š
Using key 4 or 5, select ON.
Š
press key 6 to confirm and key 1 to return to the previous menus up to the initial status.
The stanD-By function is active.
19