ROOM THERMOSTAT
22
Chapter 7
ROOM THERMOSTAT
DIGITAL THERMOSTAT (AS PER STANDARD)
The appliance can control the room temperature using a digital thermostat, which can lower the heating
power to minimum when a pre-set temperature is reached.
When the stove is started and has entered normal functioning mode, display D1 will show a number
1.
(e.g. 21°C); this value indicates the room temperature.
Use buttons 2 or 3 to enter the thermostat setting and the display will show a fl ashing word that
2.
alternates at every impulse with “
SET THERMOSTAT
” and the temperature to be set; by pressing 2 the
value decreases and by pressing 3 it increases.
Let “
3.
SET
” disappear from the display.
Adjust the desired heating power using buttons 4 and 5.
4.
When the appliance reaches the temperatures set it automatically goes to a minimum functioning mode
and the relative luminous indicator switches-off in display D1.
If digital thermostat functioning thermostat is to be excluded, use button 3, to take the temperature to
maximum until Hot appears on display D1.
The same functions can be obtained using the remote control.
ADDITIONAL THERMOSTAT (OPTIONAL)
N.B. : Installation must be performed by an authorised technician
It is possible to thermostat a room adjacent to the room where the stove is positioned: just connect a
mechanical thermostat (boiler type) following the procedure described in the next point (it is recommended
to position the optional mechanical thermostat at a height of 1.50m from the ground).
MECHANICAL THERMOSTAT INSTALLATION (OPTIONAL)
N.B. : Installation must be performed by an authorised technician
Switch the appliance off using the master switch positioned on the rear of the stove.
1.
Remove the plug from the socket.
2.
Refer to the electrical layout to connect the two thermostat cables on to the relative clamps positioned
3.
at the bottom of the machine, (the letter A arrow indicates the interested casing clamp), one is red and
the other black.
Set the room temperature set on “lou” by repeatedly pressing key 2.
4.
MECHANICAL THERMOSTAT FUNCTIONING FOR DUCTING MOTOR CONTROL
The connection of an external thermostat will allow to separate the functioning of the stove from the
functioning of the motor for the ducting, (the letter C arrow indicates the interested casing clamp).
At this point just set the desired temperature, the mechanical thermostat will control the functioning of
the second motor:
with temperature to be reached the second motor will follow the progress of the stove
